English
Start Instructions
Turning on the Water Heater
1. Make sure the gas type you will use is same as the type on the data plate.
2. Turn on the main gas valve, plug in the power cord (be sure the socket is well grounded), and
press the “ON/OFF”button on the control panel. Set temperature to 120° F.
3. Turn on the faucet, and the fan will begin working. You will hear the ignition sound after a few
seconds. The burner will ignite, and hot water will come out. If the burner is not ignited
successfully, the ignition sound will last a few seconds. If the burner still fails to ignite, turn
o the faucet and wait for 10-20 seconds, and repeat the above procedures.
For rst use and/or if the water heater has not been used for a considerable period of time, the
repeat of the above procedures may be required, due to accumulated air inside the gas pipe.
Safety Precautions
If there is any diculty in understanding or following the Operating Instructions or the Care and
Cleaning section, it is recommended that a qualied person or serviceman perform the work.
• DO NOT store or use gasoline or other
ammable vapors and liquids, such as
adhesives or paint thinner, in vicinity
of this or any other appliance. If such
ammables must be used, open doors
and windows for ventilation, and all gas
burning appliances in the vicinity should
be shut o including their pilot lights, to
avoid vapors lighting.
NOTICE: Flammable vapors can be drawn
by air currents from surrounding areas to
the water heater
• DO turn o manual gas shut-o valve if
water heater has been subjected to over
heating, re, ood, physical damage or if
the gas supply fails to shut o.
• DO NOT turn on water heater unless water
and gas supplies are fully opened.
• DO NOT turn on water heater if cold water
supply shut-o valve is closed.
• DO NOT install in a laundry room.
• DO NOT allow combustible materials such
as newspaper, rags or mops to accumulate
near water heater.
Continued...
Operating
To Next Page
Loading...
Need help?
General
