ECG MTD 2004 BA - Cooking in the Microwave Oven; Rapid Cooking; Defrosting by Weight; Defrosting by Time

43
GB
Cooking in the microwave oven
1. Press “MICROWAVE” once, the display shows “P100.”
2. Press “MICROWAVE” repeatedly or turn
to select the power level (each pressing or turn shows in order “P100”, “P80”, “P500”, “P30”
and “P10”).
3. Con rm by pressing “START/+30SEC./CONFIRM.”
4. Set the cooking time by turning
(setting is in the 0:05 – 95:00 range).
5. Press “START/+30SEC./CONFIRM” to start cooking.
Note: You can set the time at di erent intervals with following step:
0–1 minute: 5 s 1–5 minutes: 10 s 5-10 minutes: 30 s 10-30 minutes: 1 minute 30-95 minutes: 5 minutes
Cooking power table
Cooking power 100 % 80 % 50 % 30 % 10 %
Display P100 P80 P50 P30 P10
Rapid cooking
1. Press the button “START/+30SEC./CONFIRM” in the standby mode. 30 seconds of cooking starts at 100% power level. Each additional
pressing of the button extends the cooking time by 30 seconds. The maximum cooking time is 95 minutes.
2. During microwave cooking and defrosting by time you can extend the cooking time by pressing “START/+30SEC./CONFIRM.”
3. In the standby mode, you can turn the
to the left and set the cooking time directly. When you select the time, start cooking by
pressing “START/+30SEC./CONFIRM.” The microwave power level is set to 100%.
Note: In the automatic program and auto defrost by weight modes, you cannot extend the cooking time by pressing “START/+30SEC./
CONFIRM.”
Defrosting according to weight
1. Press once “WEIGHT/TIME DEFROST.” The display shows “dEF1.”
2. Turn
to set the weight of the food in the 100 g– 2000 grange.
3. Press “START/+30SEC./CONFIRM” to start defrosting.
Defrosting according to time
1. Press twice “WEIGHT/TIME DEFROST.” The display shows “dEF2.”
2. Turn to adjust the heating time.
3. Press “START/+30SEC./CONFIRM” to start defrosting.
Cooking in phases
2 di erent preparation phases at most can be set for cooking. If one of the phases is defrosting, this phase should be set as the  rst one. After
each phase is  nished, you hear an audio signal and another phase starts.
Note: Automatic menu can be set as one of the phases.
Example: If you want to defrost the food for 5 minutes and then cook 7 minutes at 80% power level, proceed as follows:
1. Press twice “WEIGHT/TIME DEFROST.” The display shows “dEF2.”
2. Turn the
to set the defrost time to 5 minutes.
3. Press once “MICROWAVE.”
4. Turn the
to set the microwave power level to 80% (it has to show “P80”).
5. Con rm by pressing “START/+30SEC./CONFIRM.”
6. Turn the
to set the cooking time to 7 minutes.
7. Press “START/+30SEC./CONFIRM” to start the food preparation.
Preset function
1. First, set the clock (see the part about clock setting).
2. Enter the cooking program. The program may have maximum two phases. The defrost mode should not be used in the preset function.
Example: If you want to cook at 80% power level for 7 minutes.
a. Press once “MICROWAVE.”
b. Turn the
to set the microwave power level to 80% (it has to show “P80”).
c. Con rm by pressing “START/+30SEC./CONFIRM.”
d. Turn the
to set the cooking time to 7 minutes.
After the steps described above, do not press “START/+30SEC./CONFIRM,” but proceed as follows:
3. Press “CLOCK PRE-SET,” the display  ashes the hour.