ECG RM 990 - Processing Recommendations; Cleaning and Maintenance

27
GB
1. Place the food in a higher cooking vessel. Do not use the blender to crush ice, cut
nuts or other hard food.
2. Place the removable attachment on the motor until it “falls” into place.
3. Uncoil the entire cord and plug into the outlet.
4. Insert the blender into the vessel with food and press the desired speed button
on the upper part of the body of the appliance. Blend with circular motions at the
bottom of the vessel, and hold it in a vertical position, never at an angle.
5. Release the button to stop the blender. Unplug the power cord from the outlet
after you are  nished blending.
Note: The maximum time of continuous operation of the appliance is 30 seconds,
allow it to rest at least 3minutes before using it again. Otherwise, it may be
damaged by overheating.
Processing recommendations
Food Max. amount Processing time
Preparation before
processing
Herbs 50 g 10 s
Nuts, almonds 150 g 15 s
Cheese 100 g 10 s 1–2 cm
Bread 75 g 20 s 2 cm
Onion 150 g 10 s halves
Biscuits 150 g 20 s 1 cm
Soft fruit 200 g 10 s 1–2 cm
CLEANING AND MAINTENANCE
Disconnect the appliance from the electrical outlet prior to performing any
maintenance. Cleaning should be always performed on a cooled appliance! Do not
use steel wool, abrasive agents or solvents.
1. Wipe the top of the blender with a wet cloth, do not immerse in water, it might
wash away the lubricant from the bearings.
2. Wipe the appliance body with a damp cloth. Never clean it under running water,
do not rinse or immerse the body into water! Attach the attachment back on to
the appliance body.
3. Wash the bottom part of the blender attachment with knives in warm, soapy
water. We do not recommend washing the dishes in a dishwasher. Always make