Echelon LONWORKS FT 5000 - FT 5000 Control Module; JP1 Connector

2 Electrical Interface
FT 5000 Control Module
The following sections describe the electrical interface for the FT 5000 Control
Module.
JP1 Connector
Figure 1 and Table 2 show the pinout of the JP1 header connector for the FT
5000 Control Module. The I/O pin function names defined in Table 2 are the
same as those used in the Series 5000 Chip Data Book, which defines the
functions and electrical characteristics for the signals. The I/O signals are
connected directly to the FT 5000 Smart Transceiver without buffering.
MOV_GND
IO2
IO0
CP2_TXLED
SVC- RST-
FT_NETA IO10
IO8
IO6 IO4
SCL
SDA_CS1-
IO11
FT_NETB
IO3 IO1 IO5 IO9 IO7
VDD3V3
CP3_RXLED
JP1
HEADER 13X2
2
4
6 8
10 12
14 16
18
20 22
24
26
1 3 5 7 9 11 13
15 17
19 21
23 25
Figure 1. FT 5000 Control Module JP1 Connector
Table 2. FT 5000 Control Module JP1 Connector
Pin Number Signal Name Description
1 GND Ground
2 RST~ Reset (active low)
3 CP3_RXLED RxActive for network activity LED
4 CP2_TXLED TxActive for network activity LED
5 NC No Connect
6 VDD3V3 3.3 V Input Power
7 GND Ground