Echo Fix EF-X2 - Page 7

USER MANUAL
UNDERSTANDING
THE EF-X2
2
Q. Speed - Adjusts the echo rate, corresponding to the heads selected with
control (L). Turn counterclockwise for longer echo times, or clockwise for
shorter. Please note: This is controlling the physical motion of a motor and
echo times will ramp up or down gradually when adjusted, with the pitch of
any repeated sound being raised or lowered accordingly.
R. Echo Volume - Adjusts the volume of the echoes mixed into the overall
output signal. Turned all the way to maximum, the echo volume is significantly
louder than the dry signal.
S. Bass - Cuts or boosts the bass frequencies of the overall output. 12 o’clock
is “flat”.
T. Treble - Cuts or boosts the treble frequencies of the overall output. 12
o’clock is “flat”.
U. Feedback - Adjusts the echo repeat level. Please note: Setting this control
past 12 o’clock will likely result in self-oscillation. Additionally, using multi-head
echo modes at higher feedback settings will increase the likelihood of self-
oscillation.
V. VU Meter - Indicates the input signal volume. Keep the signal within the
blue range for clean sounds and push into the red for saturation and distortion.
W. ON/OFF - Supplies power to the unit.
Additionally, the rear panel of the unit features balanced “In” and “Out” via XLR
connectors, for use in a live or studio environment.
4
3
2
1
7
6
5
FEEDBACKTREBLEBASS
ECHO VOLUMESPEEDREVERB VOLUMEREVERB DECAYLINE VOLUMEGUITAR/HI-Z VOLUME
ECHO MODE
CV REMOTE SPEEDLINEGUITAR/HI-Z CV REMOTE FEEDBACK REMOTE EFFECT CANCEL OUTPUT OUTPUT LEVEL
HIGH
LOW
ON
OFF
S. ON S.
ON
OFF
ECHO
ON
OFF
MOTOR
ON
OFF
DIRECT
ON
OFF
A
B
C D
E
F
G H I
J
K
L
M
N O P
Q
R
S
T
UV
W
PAGE 7 OF 12