Echo 99944100026 - Hand Held Blowers Adapter Usage; Operating Procedure for Rain Gutter Cleaning; Start the Unit; Position Pipe Assembly in Gutter

- 2 -
X7671130201 ©2017 ECHO, Incorporated All Rights Reserved
Hand Held Blowers
 Use the large (90 mm) adapter on PB-2520
models.
 Use the small (86 mm) adapter on all other hand
held models listed in this instruction sheet
.
&RQQHFW DGDSWHU * WR ¿UVW SLSH + RI EORZHU
unit.
5. Connect the pipe assembly to the adapter, se-
cure with clamp (D).
D
Operating Procedure
WARNING
Follow the safety instructions in your Power
Blower Operator’s Manual. Wear safety gog-
gles which meet ANSI Standard Z-87.1. Wear
KHDULQJSURWHFWLRQDQGDIDFH¿OWHUPDVN)DLO-
ure to read the operator’s manual and wear
safety equipment can result in serious person-
al injury.
Maintain footing and balance at all times. Do not
stand on slippery, uneven or unstable surfaces. Do
not work in odd positions or on ladders. Do not over
reach.
Keep bystanders and helpers away 15 m (50 ft.)
'LUHFW WKH DLU ÀRZ DZD\ IURP E\VWDQGHUV $OZD\V
be aware of the direction the debris will be thrown.
When the blower is started, air exiting the nozzle will
FDXVHWKHSLSHDVVHPEO\WRVZD\+ROGWKHXQLW¿UP-
ly for effective cleaning.
NOTICE
'RQRWEORFNWKH RXWOHWRIWKHSLSHDVVHPEO\
%ORFNLQJWKHRXWOHWPD\UHVXOWLQHQJLQHGDP-
age due to over-revving.
6. Start the unit.
7. Place the pipe assembly in the rain gutter. Tilt
the pipe assembly 10° from away from the rain
gutter. Angle the pipe elbow 30 to 45° in the di-
rection you will be cleaning.
10°
30 - 45°
10°
30 - 45°
8. Slide the pipe assembly along the lip of the rain
gutter. Lift the pipe assembly up an over the rain
gutter support brackets.