blade conversion kit P/N 99944200418
blade conversion kit P/N 99944200422
Models: ALL SRM Models
X7672230405
06/15
blade conversion kit
i
nstallation instructions
WARNING
You must install a Barrier Bar or U-Handle Kit and all Blade Conversion parts shown in the following instruc-
tions before operating this unit with blades, otherwise serious injury may result.
IMPORTANT
If non-standard monolament heads, METAL/PLASTIC blades or cultivators etc., are used, THE CARBURETOR
MUST BE RESET or serious engine damage can occur. See "Carburetor Adjustment" in the unit Operator's Manual.
TO USE THESE
BLADES
Pro Maxi-Cut Grass/Weed
Blade
Rigid Plastic Tri-Cut
Grass / Weed Blade
Metal Blade
You must install
these parts
Support Handle, w/or w/o
Barrier Bar
U-Handle or Support
Handle w/Barrier Bar
U-Handle or Support
Handle w/Barrier Bar
Narrow Plastic Shield w/
Knife
Narrow Plastic Shield
w/Knife
Wide Plastic Shield
Harness Harness Harness
Upper Plate & Flat Washer Upper Plate & Glide
Cup
Upper/Lower Blade
Plates
Hex Nut Hex Nut Hex Nut
New Cotter Pin New Cotter Pin New Cotter Pin
• WARNING! DO NOT INSTALL BLADES ON GT (CURVED SHAFT) MODEL TRIMMERS
• Arbor diameter of Upper Blade Plate must match arbor diameter of blades.
• New cotter pin required each time blade is installed.
• Brush Cutters over 16.5 lbs (7.5 kg) dry weight (weight w/o fuel) require a double shoulder harness
• The Barrier Bar is used to restrict rearward movement of the unit. The Barrier Bar is NOT A HANDLE and should not
be gripped when using or carrying the unit.
To Next Page
Need help?
General
