Echo CCS-58V4AH - Page 28

28 English
MAINTENANCE
Lubricate the socket at the end of the guide bar
using a grease syringe in the lubricating hole.
Turn the guide bar and check that the lubrication
holes and chain groove are free from impurities.
FLAT FILE
DEPTH GAUGE JOINTER
Fig. 42
RESTORE ORIGINAL
SHAPE BY ROUNDING
THE FRONT
Fig. 43
INCORRECT TOP PLATE FILING
ANGLE
MORE
THAN 30°
LESS
THAN 30°
Fig. 40
30°
CORRECT TOP PLATE
FILING ANGLE
INCORRECT SIDE PLATE
FILING ANGLE
BACKWARD
SLOPE
HOOK
Fig. 41
80°
CORRECT SIDE
PLATE FILING
ANGLE
Fig. 45
LUBRICATING HOLE
Fig. 44
A bar with any of the following faults should be
replaced immediately:
Wear inside the bar rails that permits the chain
to lay over sideways
Bent guide bar
Cracked or broken rails
Spread rails
Transporting and Storing
See Figure 45.

Do not store or transport the chain saw when
it is running. The chain saw should always be
idle before storing or transporting.

Remove the battery pack from the chain saw.
 Always place the guide bar scabbard on the
bar and chain before storing or transporting the
chain saw. Use caution to avoid the sharp teeth
of the chain.

Clean the chain saw thoroughly before storing.
Store the chain saw indoors, in a dry place that
is locked and/or inaccessible to children.

Keep away from corrosive agents such as gar-
den chemicals and de-icing salts.