Echo CS-350WES - TECHNICAL SPECIFICATIONS

CS-350WES
57
HANDLE AND CONTROL SYSTEM
3. Set torsion spring (F) and throttle rod (H) on
throttle trigger (E) as shown.
4. Install the throttle trigger (E) with torsion spring
and throttle rod on rear handle (K) and insert throttle
shaft (D) as follows.
Insert throttle shaft (D) in the hole of rear handle
as the tip of the shaft does not protrude inside.
Install throttle trigger (E) with torsion spring and
throttle rod using spring pin tool (C) from the other
side tentatively.
Lightly tap and insert throttle shaft (D) pushing
out the spring pin tool (C).
5. Inspect throttle control lock out (G) for cracking
or wear. Replace as required.
6. Hook end of handle cover (B) on tab (J) of rear
handle (K), and assemble handle cover (B) on rear
handle (K), setting torsion spring (F) with throttle
control lock out (G) as shown. Tighten screw
securing handle cover (B). Check throttle trigger
and throttle control lock out for moving correctly.
E
F
H
C
D
J
K
B
F
B
K
9-4 Replacing throttle trigger (continued)
G
F
G
1
2
3