10.2 REPLACE THE BLADE
Figure 10.
WARNING
Use only approved replacement blades.
WARNING
Wear heavy gloves when you touch the blade.
1. Stop the machine.
2. Make sure that the blade fully stops.
3. Remove the safety key and battery pack.
4. Turn the machine to its side.
5. Wedge a piece of wood into the deck to prevent the
movement of the blade.
6. Remove the mounting screw and spacer with a
wrench or socket.
7. Remove the blade.
8. Install the new blade. Make sure that the arrows
engage the holes in the blade.
9. Put in the mounting screw and tighten it.
Recommended tightening torque: 33-37 NM.
WARNING
Otherwise, obstacle or blade may fly and hit the
user or a person nearby, who may be injured, or
may hit and damage something.
10.3 STORE THE MACHINE
• Remove the safety key.
• Remove the battery pack(s).
• Clean the machine before storage.
• Make sure the motor is not hot when you store the
machine.
• Make sure that the machine does not have loose
or damaged parts. If it is necessary, follow these
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to your dealer.
• Store the machine in a dry area.
• Make sure that children cannot come near the
machine.
10.4 STAND THE MACHINE ON END
Figure 11.
WARNING
It is necessary to remove the safety key and the
battery pack before putting the mower in vertical
storage.
1. Remove the grass catcher.
2. Pull and turn the handle knobs 90°.
3. Fold down the handle.
4. Turn the handle knobs 90° to lock the handle into
position.
5. Stand the machine on end and make sure that the
brackets touch the floor.
6. Put the grass bag on the inside of the deck and hide
the blade during the storage position to reduce the
risk of injury from touching the blade.
11 TROUBLESHOOTING
Problem Possible cause Solution
The handle is
not in position.
The bolts are not
engaged correct-
ly.
Adjust the height
of the handle
and make sure
that the knobs
and bolts are
aligned correctly.
The machine
does not start.
The battery ca-
pacity is low.
Charge the bat-
tery pack.
The handle
switch is defec-
tive.
Replace the han-
dle switch.
The safety key is
not put in.
Put in the safety
key.
The machine
cuts grass un-
evenly.
The lawn is
rough.
Examine the
mowing area.
The blade height
is not set cor-
rectly.
Adjust the blade/
cutting height to
a higher position.
The machine
does not mulch
correctly.
Wet grass clip-
pings attach to
the deck.
Wait until the
grass dries be-
fore mowing.
The mulch plug
is missing.
Install the mulch
plug.
The machine is
hard to push.
The grass is too
tall, or the blade
height is too low.
Increase the
blade/cutting
height.
The grass catch-
er and the blade
drags in thick
grass.
Empty the grass
clippings from
the grass catch-
er.
11
English Original Instructions
EN
To Next Page
Loading...
Need help?
General
