14
Before you start
Before yo u start
Assembly
Install vacuum tube
1. Turn knob counter clockwise until hinged housing cover is
free to open for vacuum tube installation.
2. Opening housing cover, slide recess (G) on vacuum tube
into locking rib (H) , and turn the vacuum tube clockwise so
that it would be locked.
Install debris bag
1. Stand unit upright on blower base.
2. Release locking ring with a coin or screwdriver, and rotate so
that lock symbol (A) is at top of ring.
WARNING
Read the operator's manual carefully to ensure that you assemble the product correctly.
Never perform maintenance or assembly procedures with engine running.
Using a product that has been incorrectly assembled could lead to an accident or serious injury.
1. Knob
1. Vacuum tube 2. Housing cover
NOTE
Engine will not start/operate unless safety interlock switch (I) is
activated by the vacuum tube.
1. Locking ring
To Next Page
Loading...
