MAINTENANCE PE-225
34 X7732272804
© 03/21 ECHO Incorporated
◆ The cutting attachment may be moving during carburetor
adjustments.
◆ Wear your protective equipment and observe all safety
instructions.
◆ For units equipped with a clutch, be sure the cutting
attachment stops moving when the engine idles.
◆ When the unit is turned off, make sure the cutting
attachment has stopped before the unit is set down.
1. Check idle speed and reset if
necessary. If a tachometer is
available, idle speed screw
(A) should be set to the
specifications found on
“Specifications” page of this
manual. Turn idle screw (A)
clockwise to increase idle
speed; counterclockwise to
decrease idle speed.
When carburetor adjustment is completed, the cutting
attachment should not move at idle, otherwise serious personal
injury may result.
Lubrication
Level 1.
Parts Required: Lithium Grease.
Gear cases without grease plug (A) do not require lubrication.
Note: Your debris shield may appear different than the debris shield
shown.
To Next Page
Loading...
