Follow the Checklist Below Prior to Using the Machine Each Time
1. Check to ensure the engine oil is at the proper level. Refer to the engine
Owner’s Manual for the proper oil specifications.
2. Check the 2 handle knobs to ensure they are tight and will not
vibrate loose.
3. Add unleaded fuel to the gas tank. Refer to the engine owner’s manua
for proper fuel specifications.
4. Connect and tighten the garden hose to the GHA (garden hose inlet)
connection and ensure the filter screen is in place.
** Water must be turned on prior to starting the washer, pull the
spray trigger to ensure water is moving the through the lines and
out the nozzle without any leaks before starting the unit.**
5. Review the safety guidelines in the manual prior to starting the unit.
If you have any issues operating the pressure washer, call the customer
service line.
Connect Hose and Water Supply to Pump Before Starting
WARNING
DO NOT start your pressure washer without the water
supply turned on.
• Failure to do so will result in damaging the pump from overheating
and void the warranty.
WARNING
Always check the level of the engine oil prior to starting
the washer.
• Failure to do so could cause the engine to seize if the oil is low
or empty.
85.609.917_90400033BE_PW2700_PW3000_PW3100B_PW4000_PW4200_Echo Bearcat Gas PW Manual 2017.indd 1622/02/2017 4:12:38 PM
To Next Page
Loading...
