25
To apply detergent, follow these steps:
1. Review use of spray tips.
2. Prepare detergent solution as required by job.
3. Place small filter end of detergent siphoning tube into
detergent container.
NOTE: Make sure the filter is fully submerged in detergent while
applying detergent.
THIS WASHER WILL ONLY DRAW SOAP WITH THE BLACK
SOAPER NOZZLE. WHITE, RED, AND YELLOW NOZZLE WILL
NOT DRAW SOAP.
4. Make sure black spray tip is installed.
5. Make sure garden hose is connected to water inlet. Check that high
pressure hose is connected to spray gun and pump. Turn on water.
NOTICE
You must attach all hoses before you start the engine.
• Starting the engine without all the hoses connected and without the
water turned ON will damage the pump.
• Damage to equipment resulting from failure to follow this instruction
will void warranty.
6. Start engine following instructions Starting Your Washer.
7. Apply detergent to surface, using long, even, overlapping strokes.
8. Allow detergent to “soak in” for 5 minutes before washing and
rinsing. Reapply as needed to prevent surface from drying. DO NOT
allow detergent to dry on.
IMPORTANT: You must flush the detergent siphoning system after each
use by placing the filter into a bucket of clean water, then run the
pressure washer in low pressure for 1-2 minutes.
CAUTION
Chemicals can cause bodily injury and/or property damage.
• NEVER use caustic liquid with pressure washer.
• Use ONLY pressure washer safe detergent/soaps. Follow all
manufacturers instructions
To Next Page
Loading...
