6. To start the PW2700, pull the
Choke rod to the CLOSED
position. NOTE: For a warm
engine, be sure the choke is in
the OPEN position (no choke).
7. Move the Throttle Control lever
to the “Slow” position about
1/3 of the way towards the
“Fast” position. NOTE: Once
the egnine has warmed up
always keep the Throttle Con-
trol lever in the “Fast” position
when operating the pressure washer.
8. Grasp starter grip and pull
slowly until you feel some
resistance. Then pull cord out
with rapid full arm stroke. Let
rope return slowly. Do Not
let rope “snap back” against
starter.
9. If the engine fails to start
repeat above steps or refer to
the engine owner’s manual.
10. If the choke was pulled to
the CLOSED position to start
the engine, slowly push it to the OPEN position as soon as the engine
warms up enough to run smoothly.
To start the PW3100B, locate the ON/OFF
switch on the side of the motor, and switch
it to the ON position.
ON
OFF
PW3100B
PW2700
85.609.917_90400033BE_PW2700_PW3000_PW3100B_PW4000_PW4200_Echo Bearcat Gas PW Manual 2017.indd 1822/02/2017 4:12:38 PM
To Next Page
Loading...
