SHAFT HEDGE CLIPPER
OPERATOR'S MANUAL
19
4. Start - Pull Rope.
Lay the shaft hedge clipper on a flat clear area and pull the recoil
starter handle (D) until engine fires.
5. Open Choke - Run.
Move the choke lever to the OPEN - RUN position. Restart engine
if necessary and allow to warm up running at idle for several
minutes.
STARTING WARM ENGINE
The starting procedure is the same as Cold Start except DO NOT close
the choke.
NOTE
If engine does not start after 5 pulls, use Cold Start Procedure.
WARNING DANGER
When engine starts, the cutting attachment may move even with
the throttle trigger in idle (released) position.
1. Stop Switch - Start/Run. Move stop switch button (A) away from
the STOP position.
2. Primer Bulb - Pump primer bulb until fuel is visible and flows freely
in the clear fuel tank return line. Pump bulb an additional 4 or 5
times.
3. Start - Pull Rope. Lay the shaft hedge clipper on a flat clear area
and pull the recoil starter handle (D) until the engine fires.
D
D
C
A
To Next Page
Loading...
Need help?
General
