42
Power Options
Power-saving settings can be configured using this menu. Options allow you to
select the power consumption in standby mode.
Power Mode
Power saving mode
used when unit enters
standby:
Low power standby*
Lowest power consumption but the receiver will
take longer to switch to the active or ON state.
Normal power standby
Faster switching on; higher power consumption.
Inactivity Standby
Define time period before the receiver goes into
standby if no remote control or front panel keys are
operated: Off, 4 Hours*, 5 Hours, 6 Hours
Technical Information
This menu displays software version and other technical information.
Tuning
Services
Lists all channels.
Manual scan
Carry out a manual scan for services by setting UHF
channel, Frequency. bandwidth, System type
(advanced users only)
Factory Reset
Choose this option to restore the default configuration settings or when you
need to retune or have moved house and need to perform the installation
again.
Note. In addition to removing all your personal settings, this will cancel any
scheduled recordings. Existing recordings are not affected and previously
saved content will not be deleted.
To Next Page
Loading...