11
PARAMETER LINK MODE 2X3 WAYS 3X2 WAYS (LCR 2WAY)
Input Delay Offset A(CH1)-B(CH2) A(CH1)-B(CH2)
Input EQ type Step A(CH1)-B(CH2) A(CH1)-B(CH2)
Input EQ frequency Offset A(CH1)-B(CH2) A(CH1)-B(CH2)
Input EQ gain (+/-) Offset A(CH1)-B(CH2) A(CH1)-B(CH2)
Output Name Offset 1-2, 3-4, 5-6 1-3, 4-6
Output Source Offset A(1,3&5) & B(2,4&6) A(1&4)/B(2&6)/A+B(3&5)
Output Gain Offset 1-2, 3-4, 5-6 1-3, 4-6
Output Limiter Offset 1-2, 3-4, 5-6 1-3, 4-6
Output Delay Offset 1-3, 3-5, 2-4, 4-6 1-4, 2-5, 3-6
Output Delay link Offset 1-3, 3-5, 2-4, 4-6 1-4, 2-5, 3-6
Output Polarity Step 1-2, 3-4, 5-6 1-3, 4-6
Output bass curve Step 1-2, 3-4, 5-6 1-3, 4-6
Output bass frequency Offset 1-2, 3-4, 5-6 1-3, 4-6
Output treble curve Step 1-2, 3-4, 5-6 1-3, 4-6
Output treble frequency Offset 1-2, 3-4, 5-6 1-3, 4-6
Output EQ type Step 1-2, 3-4, 5-6 1-3, 4-6
Output EQ frequency Offset 1-2, 3-4, 5-6 1-3, 4-6
Output EQ gain (+/-) Offset 1-2, 3-4, 5-6 1-3, 4-6
Output EQ width Offset 1-2, 3-4, 5-6 1-3, 4-6
MONO mode
In mono mode, the processor is configured as follows:
- All outputs (1-6) are connected to input CH1 (A).
- Crossover frequencies are set up to cover the entire audio frequency range. (Full range
operation).
- The default Delay link is set to OFF.
- No stereo linking is allowed.
- The names of the outputs are set to “Band 1” to “Band 6” for Outputs “OUT 1” to “OUT6”
respectively.
To Next Page