15
9. SOFTWARE
DP:lab2 software
The DP400 processor works together with the DP:lab2 software which allows the
remote configuration of all device parameters from a standard PC or laptop with following
specifications:
- Intel P3 processor or equivalent at 600 MHz.
- 256 Mbytes of RAM memory.
- Windows 98 SE, XP Home, XP Professional, Windows 2000 or Vista operating system.
With the use of this software application, the operating mode, the crossover filters and the input
and output equalizations can be configured in the same aspects as would be done from the unit itself.
The communication between the PC and the DP400 unit is done with a USB cable.
It is important to keep in mind that when using DP:lab2 to manage the DP400, the controls on the
front panel of the unit will be disabled and the LCD screen will say REMOTE CONTROL.
To Next Page
Loading...