Need help?Do you have a question about the Ecler DPA1000 and is the answer not in the manual?
General| Total Harmonic Distortion (THD) | < 0.05% |
|---|---|
| Signal-to-Noise Ratio | > 100 dB |
| Cooling | Variable speed fan |
| Frequency Response | 20 Hz - 20 kHz |
| Input Sensitivity | 1.4V (for full power) |
| Input Impedance (Balanced) | 20 kOhm |
| Input Impedance (Unbalanced) | 10 kOhm |
| Protection | Thermal, short circuit, DC |
| Connectors (Inputs) | XLR and 1/4" TRS |
| Connectors (Outputs) | Speakon, binding posts |
| Power Supply | 100-240V, 50/60Hz |
Essential safety measures for installation and operation, including mains, environment, and connections.
Proper placement and airflow management for optimal performance and longevity.
Information on power supply requirements and cable placement to prevent humming.
Details on XLR and 1/4" jack input connections and pin assignments.
Explanation of the switchable subsonic filter and its benefits for low frequencies.
Description of the ANTICLIP circuitry for automatic distortion control.
Instructions for Speakon connectors and bridged mode operation.
Procedure for powering on the amplifier and correct sequence.
How to use front panel volume controls and protective caps.
Overview of front panel status indicators like CLIP/PROT and SP.
Detailed explanation of CLIP/PROT, THERMAL, and SP indicator functions.
Schematic figures showing internal layouts and jumper configurations for DPA600/1000/1400.
Schematic diagrams specific to the DPA2000 model.
Functional block diagram for DPA600, DPA1000, and DPA1400 amplifiers.
Functional block diagram for the DPA2000 amplifier.
To Next Page
