7
7. POSITIONING, FITTING AND START-UP
In the packing of eMOTU5OD, you will find all that is needed to complete installation of
the unit.
The following should be observed as general rules:
• Always install on solid, firm surfaces.
• For good sound reproduction, there should be no hindrance between the units
and the audience.
• Adjust the levels of sound pressure to reproduction requirements. Despite its
small size, the eMOTUS5OD has a performance far higher than that of domestic
loudspeakers.
Procedure for installing on a surface:
1. Make three 6 mm drill holes in the wall, lining them up with the position of the
holes in the bracket.
2. Insert three 6 mm wall plugs in these holes.
3. Fasten the safety line on the back of the bracket.
To Next Page
Loading...
