Ecleris MINIVAC - User Manual

Questions and Answers

J
James MccallAug 21, 2025
How to troubleshoot an Ecleris Medical Equipment Minivac that does not start?
- N
  Nicholas ClarkAug 21, 2025
  If your Ecleris Minivac isn't starting, consider these possible causes: * It might not be properly connected to the electrical network. Ensure the power supply cable is securely connected. * The power supply cable could be damaged. If it's broken or cut, replace it. * The plug might be in poor condition. If so, replace the plug. * The fuse might be blown. Replace the fuse.
A
Andrew CollierAug 31, 2025
Why is my Ecleris Medical Equipment Minivac making a strange noise?
- S
  Stanley HunterAug 31, 2025
  If your Ecleris Minivac is making unusual noises, there are a couple of potential reasons: * The voltage selection could be incorrect. Make sure the voltage selector switch matches the voltage of your electrical network. * The device may not be on a stable surface. Place the device on a vibration-free surface.
E
Ernest PerezNov 10, 2025
What to do if my Ecleris Medical Equipment Minivac starts but doesn't produce vacuum?
- J
  josephhurstNov 11, 2025
  If your Ecleris Minivac starts but isn't creating a vacuum, several factors could be at play: * The vacuum regulator might be completely open. Try closing it by turning it clockwise. * The suction piping could be throttled. Ensure the hose isn't pinched or blocked. * There might be leakages in the piping. Inspect the piping and replace any damaged sections. * The collecting bottle may not be sealed correctly. Check that the bottle is properly closed and the O-ring is in place. * The filter could be obstructed. Remove it from the bottle and clean it thoroughly. * The voltage selector switch is set at 220V and the electrical network in use is of 110 V. Place the voltage selector switch according to the electrical network in use. * There could be dirt or debris inside the hose ...