Eclipse Aviation Eclipse 500 - Page 43

12/8/2006 FLIGHT TRAINING AND STANDARDS MANUAL
ECLIPSE 500
© Eclipse Aviation Corporation, 2006
43
11. L PFD Circuit Breaker SET
• Verify circuit breaker pressed in
12. L ACS Circuit Breaker SET
• Verify circuit breaker pressed in
13. R GEN Switch AUTO
14. BUS TIE Switch AUTO
15. SYSTEM BATT Switch ................................... ON
16. L GEN Switch……………...………………………………………….AUTO
17. ELT Switch…………………………………………………………..ARM
18. Passenger Mask……………………………………………………AUTO
19. AIR SOURCE Switch…………………………………………………OFF
20. External Lights…………………………………………….AS REQUIRED
• Turn Beacon light on.
21. Gear Indication……………………………………………THREE GREEN
22. Parking Brake………………...............................................................SET
• Pulling the parking brake handle without simultaneously depressing the brake
pedals will not
engage the parking brake, even though the PARKING BRAKE
status message is illuminated.
23. COMM / NAV…………………………………………………………….SET
• Set tower and departure frequencies in comm. #1. Use comm. #2 for all ground
frequencies (ATIS, clearance delivery, ground control, etc). This will allow a simple
change to comm. #1 when ready to talk to tower.
• Set the two navaids likely to be initially used in both nav #1 and nav #2.
24. Altimeter………………………………………………………………SET
• Use ATIS/ASOS/AWOS altimeter setting. If no weather source available, set
airport elevation.