Eclipse Aviation Eclipse 500 - Conduct Departure Self-Briefing

To Next Page

To Previous Page

12/8/2006 FLIGHT TRAINING AND STANDARDS MANUAL

ECLIPSE 500

• YD OFF/ON button on the Autopilot Control Panel

• AP OFF/ON button on the Autopilot Control Panel

• AP mode buttons on the Autopilot Control Panel

c. STALL PROTECTION SYSTEM TEST

• Select STALL PROTECTION and START TEST

• Verify “STALL” appears on ADI and aural “STALL” warning is heard

• Verify stick pusher function activates and control stick moves forward

• Pull back on control stick to overpower stick pusher, then release pressure

• Verify stick continues to push forward after overpower is relaxed

• Select STOP TEST

3. Electronic Circuit Breakers ..............CHECKED

• Select ECB synoptic page and check for tripped/pulled/collared ECBs

4. FLAPS ................................ SET FOR TAKEOFF

• TO or UP, based on preflight performance planning

5. PARKING BRAKE ............................RELEASED

6. External Lights ...........................AS REQUIRED

• Turn taxi light on when beginning to taxi. Flash the taxi light to signal the ground

crew of intent to commence taxi.

7. Air Source Switch……………......NORMAL (see note)

NOTE

If OAT is greater than 75°F / 24° C, the Air Source Switch may be set to OFF before and

during taxi to reduce air conditioning workload.

8. Seats Inertia Reel LOCKED

Conduct departure self-briefing

TAXI

1. Brakes .....................................................CHECK

2. Engine Instruments................................CHECK