Route the parking brake signal cable to the main
unit.
-
11
-
Foot-operated
Parking brake
Hand-operated
Parking brake
-
A connecting the point for parking brake (example)
-
Attach a splicing
connector at this location.
Reverse signal cable
Reverse lamp
Reverse signal cable
-
A connecting point for the reverse signal (example)
-
••
Be sure to connect the reverse signal cable. If it is
not connected, the vehicle position may be
incorrect when the vehicle is reversed.
••
Use a circuit tester to confirm that a sensing
voltage of 6 V or higher is generated when the
vehicle is reversed.
Tip
-
Using the splicing connector
-
Insert the connection cable [vehicle speed pulse
signal cable (purple/white), parking brake signal
cable (red/white), or reverse signal cable
(green)] from the main unit and the vehicle cable
into the splicing connector.
1
Push in the terminal (the metal part) of the
splicing connector using a pair of pliers.
2
Harness in the car
Vehicle speed pulse signal cable
(purple/white), parking brake cable,
(red/white) or reverse cable (green)
Splicing connector
10
Press down the cover of the splicing connector
and squeeze it until it locks.
3
Lock
Splicing connector
10
Use a splicing connector to connect the reverse
signal cable (green) coming from the main unit to
the reverse signal cable of the vehicle.
1
Route the reverse signal cable to the main unit .
2
Use a splicing connector to connect the parking
brake signal cable (red/white) coming from the
main unit to the parking brake signal cable of the
vehicle.
1
2
Parking brake
Signal Cable
Attach a splicing
connector at this location.
Parking brake
signal cable
To Next Page
Loading...
