How to operate the receiver with an optional DSP/EQ unit or Digital Sound Processor connected
88
4. Press the [AUDIO CONTROL] button to select the
speaker to be adjusted.
5. Turn the [AUDIO CONTROL] button to the left or
right to adjust the speaker level.
6. Press the [FUNC] button to return to the setting
mode.
7. Press the [FUNC] button again to cancel the setting
mode.
Setting the level memory
This is a function to store the speaker level adjusted for
each speaker in speaker setting mode.
1. Set the speaker to a state to be stored.
2. Press the [FUNC] button.
3. Press button [3] for less than one second.
The state shifts to the level memory mode.
4. Press and hold any number button to store settings
for more than two seconds.
The level will be stored.
5. Press the [FUNC] button.
The level memory mode will be canceled to return to
the normal status.
To Next Page
Loading...
Need help?
General
