Eclipse CD8051 - User Manual

Questions and Answers

S
Samantha CharlesAug 18, 2025
What to do if my Eclipse Car Receiver has dead or weak sound?
- T
  Tina MoralesAug 18, 2025
  If you are experiencing dead or weak sound with your Eclipse Car Receiver, there are several possible causes. First, check if the volume control is turned up sufficiently. If not, turn up the volume. Also, verify that the muting function is not active; if it is, cancel it. Ensure that the fader and balance controls are not set far to one side; readjust them to more normal positions. If these steps don't resolve the issue, the problem may be broken audio-signal wiring or a faulty speaker, and it is recommended to have your dealer check it out.
M
Mr. Jeremy AlexanderAug 20, 2025
Why does my Eclipse Car Receiver receive no stations or only static noise?
- D
  David MillerAug 20, 2025
  If your Eclipse Car Receiver receives no stations or only static noise, consider these possible causes: * Check if the antenna is fully extended; if retracted, extend it. * Ensure the tuner is correctly tuned to a station; if not, tune it properly. * If driving, determine if you are outside the service area of your preset stations and tune to a local station instead. * Avoid operating other equipment with a computer or mobile phone in your vehicle at the same time as your receiver, as this may cause interference. If the issue persists, the problem may be a loose or disconnected antenna cable, a bad antenna cable, or a faulty antenna, and it is recommended to have your authorized Eclipse retailer check the problem.
W
wkeyAug 23, 2025
What to do if the Eclipse Car Receiver remote control does not work?
- S
  Stephen ZamoraAug 23, 2025
  If the remote control for your Eclipse Car Receiver isn't working, start by checking the battery. If the battery is low, replace it. Ensure that the battery is installed with the correct polarity. Also, make sure that direct sunlight isn't hitting the remote control light receptor; if it is, use the remote control closer to the receptor. If the issue persists, the remote control may be malfunctioning, and it is recommended to have your dealer check the problem.
N
noahgarciaAug 26, 2025
Why does the sound skip around or have bad quality on my Eclipse Car Receiver?
- S
  Sandra ScottAug 26, 2025
  If the sound skips, is intermittent, or has bad quality on your Eclipse Car Receiver, consider the following: * Check the disc for damage (scratches, warping, etc.). If damaged, try another disc and avoid playing damaged discs. * Ensure the disc is clean; if not, clean it. * Avoid playback while driving over rough surfaces. If the issue continues, it is recommended to have your dealer check the mounting angle and ensure the player is mounted properly.
B
Brittney DelgadoAug 28, 2025
Why are frequencies or titles deleted from memory on my Eclipse Car Receiver?
- C
  christian63Aug 28, 2025
  If frequencies or titles set in memory are being deleted on your Eclipse Car Receiver, it may be because the car battery has been disconnected for repair or checked out. If this is the case, reenter them into memory. It could also be that too many electrical items are installed, causing a lack of available power, or there may be a run-down car battery, broken power, or interconnection wiring. If the issue persists, it is recommended to have your dealer check the problem.
S
Steven MartinezAug 30, 2025
How to fix Eclipse Car Receiver when power does not turn on?
- A
  Anthony KellyAug 30, 2025
  If your Eclipse Car Receiver is not turning on, it could be due to too many electrical items installed, causing a lack of power. If this is the case, it is recommended to have your dealer check the problem. Other possible causes include a run-down car battery, broken power, or interconnection wiring, which should also be checked by your dealer.
T
Taylor ArmstrongSep 2, 2025
What to do if the disc cannot be inserted or ejected from the Eclipse Car Receiver?
- M
  Mason CarrollSep 2, 2025
  If a disc cannot be inserted or ejected from your Eclipse Car Receiver, first check if there is an extra label or seal applied to the disc. If so, remove it, as labels and seals should not be applied to discs. Also, check the disc for rough edges, deformations, or damaged areas. Try inserting another disc, remove any burrs, and avoid using deformed or damaged discs.
M
Mark BakerSep 4, 2025
What to do if an internal power supply failure occurs with the Eclipse Car Receiver auto changer?
- O
  ortizchristopherSep 4, 2025
  If an internal power supply failure is occurring with the auto changer on your Eclipse Car Receiver, turn the ACC off once before turning it on again to resume operation. If the function still cannot be restricted, contact your dealer.
B
Becky WiseSep 6, 2025
What to do when the CD changer internal temperature is high in my Eclipse Car Receiver?
- A
  Anthony WilsonSep 7, 2025
  If the CD changer internal temperature is high in your Eclipse Car Receiver, wait until it cools down. Resume playing after the 'High temperature sensed and CD stopped' display disappears. If the CD still cannot play, have your dealer repair it.
T
Tony GraySep 9, 2025
How to eject a disc from Eclipse Car Receiver?
- Q
  qweeksSep 10, 2025
  To eject a disc from your Eclipse Car Receiver, press the [SOURCE] button a bit longer and then press the [OPEN] button (forced Eject).

Eclipse CD8051 Specifications

General

Motorized Faceplate	Yes
Subwoofer Output	Yes
Display Type	LCD
CD Playback	Yes
MP3 Playback	Yes
WMA Playback	Yes
ID3 Tag Display	Yes
Remote Control	Yes
Channels	4
Built-in Amplifier	Yes
Radio Tuner	AM/FM
Auxiliary Input	Yes
Bluetooth	No
Preset Stations	18 FM/6 AM