Eclipse GEO User Manual

REL TM
THE RELEASE TIME PARAMETER
The REL TM parameter is used to set the minimum
amount of time that the trigger must be released
before it is recognised as a valid trigger release.
This parameter can be set between 3.0 and 25.0
milliseconds in 0.1 ms increments.
PULL PT
THE PULL POINT PARAMETER
The PULL PT parameter is only available if OPTO has
been selected in the Hardware Menu. PULL PT defines
the point at which the trigger is considered pulled and
is adjustable between 51% and 99% in 1% increments.
FULL
THE FULL PARAMETER
Tumbling paintballs can take time to settle in the
breech before they can be successfully fired. This
parameter is used to set the amount of time that a
paintball has to be in the breech before the Geo is
allowed to fire. This parameter can be set between 1.0
and 20 milliseconds in 0.5ms increments.
PULL TM
THE PULL TIME PARAMETER
The PULL TM parameter is used to set the minimum
amount of time that the trigger must be pulled before
it is recognised as a valid trigger pull. This parameter
can be set between 1.0 and 20.0 milliseconds in 0.5 ms
increments.
ADVANCED SET-UP
48.
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR GEO
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTERS
PARTS LIST
SPARES & ACCESSORIES
49.
ADVANCED SET-UP
ADVANCED SET-UP
QUICK GUIDE

Eclipse GEO Specifications

General

Manufacturer	Planet Eclipse
Power Source	9V Battery
Caliber	.68
Firing Modes	Semi-Auto, Ramping, Full Auto
Rate of Fire	20+ BPS
Height	200mm
Air Source	High Pressure Air (HPA)