Need help?Do you have a question about the Eclipse ETEK 5 and is the answer not in the manual?
Initial configuration and checks for the ETEK5.
Step-by-step instructions for battery installation.
How to turn the marker on/off and fire it.
Information on the internal circuit board and optional OLED upgrade.
Using the breech sensor and understanding the navigation console.
Attaching barrel, macroline, and loader.
Installing air systems and adjusting trigger parameters.
Modifying velocity and safely unloading the marker.
Guidelines for safe storage, transport, and tournament lock activation.
How to enter set-up mode and change marker parameters.
Setting firing presets and maximum rate of fire (ROF).
Adjusting dwell, debounce, and resetting to factory defaults.
Detailed instructions for fitting the OLED board.
Understanding the OLED screen, LED, and buttons.
Accessing and adjusting parameters like Preset, ROF, Dwell, etc.
Procedure for cleaning the ETEK5 breech sensor.
Steps for maintaining the SL4 inline regulator assembly.
Cleaning and lubricating the bolt and maintaining the rammer.
Maintenance procedures for the ETEK5 solenoid assembly.
Steps for maintaining the valve assembly and OOPS.
How to locate official service centres for repairs.
Explanation of the firing cycle and a list of all parts.
Detailed diagrams of regulators, bolt, rammer, solenoid, etc.
Reference charts for common o-ring and screw sizes.
A table summarizing all adjustable parameters for the OLED board.
Initial configuration and checks for the ETEK5.
Step-by-step instructions for battery installation.
How to turn the marker on/off and fire it.
Information on the internal circuit board and optional OLED upgrade.
Using the breech sensor and understanding the navigation console.
Attaching barrel, macroline, and loader.
Installing air systems and adjusting trigger parameters.
Modifying velocity and safely unloading the marker.
Guidelines for safe storage, transport, and tournament lock activation.
How to enter set-up mode and change marker parameters.
Setting firing presets and maximum rate of fire (ROF).
Adjusting dwell, debounce, and resetting to factory defaults.
Detailed instructions for fitting the OLED board.
Understanding the OLED screen, LED, and buttons.
Accessing and adjusting parameters like Preset, ROF, Dwell, etc.
Procedure for cleaning the ETEK5 breech sensor.
Steps for maintaining the SL4 inline regulator assembly.
Cleaning and lubricating the bolt and maintaining the rammer.
Maintenance procedures for the ETEK5 solenoid assembly.
Steps for maintaining the valve assembly and OOPS.
How to locate official service centres for repairs.
Explanation of the firing cycle and a list of all parts.
Detailed diagrams of regulators, bolt, rammer, solenoid, etc.
Reference charts for common o-ring and screw sizes.
A table summarizing all adjustable parameters for the OLED board.
General| Manufacturer | Planet Eclipse |
|---|---|
| Model | ETEK 5 |
| Marker Type | Electronic |
| Battery Type | 9V |
| Body Material | Aluminum |
To Next Page
