CONTENTS
4 ETEK5 MANUAL
USING THE ETEK5
Details on how to get up and running quickly with your ETEK5.
This section is essential reading for everyone.
6 Factory set-up guide
7 Installing a 9v battery
8 Switching on the ETEK5
Switching off the ETEK5
Firing the ETEK5
9 Switching on the ETEK5 with OLED board tted
Switching off the ETEK5 with OLED board tted
Firing the ETEK5 with OLED board tted
10 The ETEK5 circuit board
11 The ETEK5 OLED board
12 Using the Breech Sensor
13 Using the Breech Sensor with OLED board tted
14 The ETEK5 navigation console
15 Setting up the ETEK5
Installing a barrel
16 Straight macroline ttings
Macroline hosing
17 Installing a preset air system
19 Attaching a loader
20 Setting the trigger
21 Adjusting the velocity
Adjusting the LPR pressure
22 Unloading the ETEK5
23 Storage and transportation
24 The tournament lock
25 Understanding the Breech Sensor operation
The battery level indicator
ADVANCED SET-UP
In depth information on setting up the ETEK5.
26 The SET-UP mode
Modifying a parameter
27 SET-UP parameters
The PRESET parameter
Maximum ROF with Breech Sensor on (capped modes)
Maximum ROF with Breech Sensor off
28 DWELL - Controls the amount of gas that is released with each shot
DEBOUNCE - Adjusts the amount of trigger bounce
THE FACTORY RESET - Resets all settings back to factory standard
ETEK5 OLED BOARD
In depth information covering all aspects of the ETEK5 OLED Circuit Board.
29 Installing the ETEK5 OLED board
30 ETEK5 OLED board navigation console
31 Switching on
Run screen layout
32 The Breech Sensor indicator
The lock indicator
The battery level indicator
33 The SETUP mode
34 PRESET - Selection of compliant preset ring modes
BS ON ROF - Maximum rate of re with Breech Sensor on
BS OFF ROF - Maximum rate of re with Breech Sensor off
35 KICK IN - Rate that the trigger must be pulled per second to begin ramping
RESTART - Time in seconds that ramping can restart after each trigger pull
DWELL - Solenoid energise time in milliseconds
DEBOUNCE - Trigger anti-bounce settings
36 SLEEP - Auto power off time in minutes
DISPLAY - Denes what information is displayed on the run screen
ZERO - Allows user to set the display variables to zero
To Next Page
Loading...
Need help?
General
