USING THE ETEK5
ETEK5 MANUAL 17
WARNING!
Make sure the marker is turned off with a barrel blocking device installed
and that no paintballs are in the ETEK5 or loader before installing an air
system.
Compressed air and nitrogen systems can be extremely dangerous if
handled or used incorrectly.
Only use an air system certied for use within the country of use.
The ETEK5 cannot be used with CO2. Only use compressed air or nitrogen.
Never add any lubricants or greases into the ll adaptor of the air system
regulator.
Ensure that all screws are tightened and no parts are loose before installing
an air system.
Do not pressurise the ETEK5 without the bolt system correctly installed, as
high pressure gas will be emitted.
Do not install a compressed air system or load paintballs into the ETEK5
until you feel completely condent with your ability to handle the marker
safely and responsibly.
Always relieve all residual gas pressure from the ETEK5 before unscrewing
the preset air system.
INSTALLING A PRESET AIR SYSTEM
To Next Page
Loading...
Need help?
General
