Eclipse ETEK 5 User Manual

USING THE ETEK5
ETEK5 MANUAL 9
SWITCHING ON THE ETEK5 WITH OLED BOARD FITTED
At the rear of the frame is the navigation console which houses the Select button
(labelled
A
gure 4A). This button is the disabling device for the ETEK5, used to switch
the marker on and off. Press and hold the
button until the ETEK5 OLED board begins
its power up sequence.
1,2
SWITCHING OFF THE ETEK5 WITH OLED BOARD FITTED
Press and hold the button until the display shows GOODBYE. Release the button.
FIRING THE ETEK5 WITH OLED BOARD FITTED
If the Breech Sensor (BS) is disabled, pull the trigger to re the ETEK5. If the Breech
Sensor is enabled and there is a paintball in the breech, pulling the trigger will also re
the ETEK5. The entire ring sequence is controlled electronically by the ETEK5 board and
solenoid, enabling any user to achieve high rates of re easily.
1 When the ETEK5 is turned on, the Breech Sensor is automatically enabled.
2 By continuing holding down the
button when turning on the ETEK5 OLED board the software
version number will be displayed.
FIG 4A
A

Eclipse ETEK 5 Specifications

General

Brand	Eclipse
Model	ETEK 5
Category	Paintball equipment
Language	English