USING THE ETEK5
22 ETEK5 MANUAL
UNLOADING THE ETEK5
Securely attach a barrel blocking device such as the Eclipse Barrel Sock
1
(supplied with the ETEK5) to the marker as shown in gure 16A.
Turn off the ETEK5 - see pages 8 and 9 for information on turning off the ETEK5
via the navigation console (see gure 16B).
With the ETEK5 barrel pointing away from you. De-gas the marker by turning
OOPS knob clockwise until the OOPS begins to vent air. Only when the OOPS
has fully degassed the ETEK5 marker should you unscrew the air system from
the OOPS (see gure 16C).
Open the clamping lever on the feed neck and slacken off the top feed screw
if necessary on the feed neck. Carefully pull the loader out of the feed neck
(see gure 16D).
Looking down the feed neck, check to see if there are any paintballs still in the
breech, if there are, turn the marker upside down while still keeping the barrel
facing away from any persons within ring range then tip out any paintballs within
the breech (see gure 16E).
Next remove the barrel blocking device, and unscrew the barrel (see gure 16F).
Remove any paintballs within the barrel.
The ETEK5 has now been unloaded and is ready for storage.
1 Instruction on using the Eclipse Barrel Sock can be found on the sock warning label.
WARNING!
Always keep the Eclipse ETEK5 pointed in a safe direction and ensure
all persons within range continue to wear face protection, until marker is
completely unloaded and safe.
FIG 16E
FIG 16F
FIG 16C FIG 16D
FIG 16A FIG 16B
To Next Page
Loading...
Need help?
General
