SWITCHING ON THE ETEK5
At the rear of the frame is the navigation console which houses the Select button
(labelled
A
gure 3A). This button is the disabling device for the ETEK5,
used to switch the marker on and off. Press and hold the Select button .
Release the Select button when the LED lights up and your ETEK5 will begin
its power up sequence.
1,2
SWITCHING OFF THE ETEK5
Press and hold the Select button . Release the Select button when the LED
on the navigation console turns red.
FIRING THE ETEK5
If the Breech Sensor (BS) is disabled, pull the trigger to re the ETEK5. If
the Breech Sensor is enabled and there is a paintball in the breech, pulling
the trigger will also re the ETEK5. The entire ring sequence is controlled
electronically by the ETEK5 circuit board and solenoid, enabling any user to
achieve high rates of re easily.
1 When the ETEK5 is turned on, the Breech Sensor is automatically enabled.
2 The colours displayed during the power up sequence may vary depending on the region the
marker was originally purchased.
USING THE ETEK5
8 ETEK5 MANUAL
FIG 3A
A
To Next Page
Loading...
Need help?
General
