USING THE ETEK5
12 ETEK5 MANUAL
WARNING!
The ETEK5 may still re even if there is no paintball in the breech. Always
ensure all safety guidelines are followed when the ETEK5 is switched on.
FIG 7A
A
B
USING THE BREECH SENSOR
The Breech Sensor (BS) is used to detect when a paintball is ready to re from
the ETEK5. If no paintball is ready then the BS will inhibit the ETEK5 from ring.
This prevents the ETEK5 from ‘chopping’ paintballs that are not fully loaded into
the marker.
When the ETEK5 is powered up, the Breech Sensor (BS) is automatically
enabled.
To switch off the Breech Sensor, push and hold the Select button
(labelled
B
gure 7A) for 0.5 seconds. The LED (labelled
A
gure 7A) on
the navigation console (see page 14 for more information about the navigation
console) will ash purple indicating that the Breech Sensor has been disabled.
To switch on the Breech Sensor, push and hold the Select button
for 0.5
seconds. The LED on the navigation console will ash either yellow (no ball
detected) or light blue (ball detected) indicating that the Breech Sensor has been
enabled.
Additional features of the ETEK5 Breech Sensor are covered in full in the
‘Understanding the Breech Sensor Operation’ section on page 25 of this
User Manual.
To Next Page
Loading...
Need help?
General
