Eclipse ETEK 5 User Manual

USING THE ETEK5
ETEK5 MANUAL 13
WARNING!
The ETEK5 may still re even if there is no paintball in the breech. Always
ensure all safety guidelines are followed when the ETEK5 is switched on.
WARNING
USING THE BREECH SENSOR WITH OLED BOARD FITTED
When the ETEK5 is powered up, the Breech Sensor (BS) is automatically
enabled.
The LED on the navigation console will display the same Breech Sensor
information regardless of the ETEK5 OLED board being installed or not.
To switch off the Breech Sensor, press and hold the Select button
on the
navigation console (see page 14 for more information about the navigation
console) for 0.5 second (labelled
A
gure 8A).
The Breech Sensor indicator on the top right of the OLED display will show
to indicate its ‘Disabled’ status (labelled
B
gure 8A).
To switch the Breech Sensor to ‘Enabled’, press and hold the
button for one
second. The indicator will change back to
.
More detailed features of the ETEK5 OLED board’s Breech Sensor are covered in
full on page 32 of this user manual.
FIG 8A
A
B

Eclipse ETEK 5 Specifications

General

Brand	Eclipse
Model	ETEK 5
Category	Paintball equipment
Language	English