HARDWARE
THE HARDWARE MENU
The Hardware Menu comprises parameters that control
low level functionality of the Geo electronic hardware.
TRIGGER
THE TRIGGER PARAMETER
The Geo is fitted with a dual trigger pull
detection system. A non-contact opto-
electronic trigger sensor arrangement
is used to detect trigger movement
whilst a micro-switch is used to provide a
more traditional tactile feedback for the
trigger. The TRIGGER parameter is used to
select which system is used. The choices
available are as follows:-
> OPTO:
Select the Opto sensor for trigger
pull detection.
> SWITCH:
Select the micro-switch for
trigger pull detection.
> CANCEL:
Cancel editing and leave the
parameter unchanged.
SOUND
THE SOUND PARAMETER
The Geo board is capable of emitting a
variety of sounds to audibly indicate when
certain functions have been performed,
including, but not limited to, powering up,
powering off, changing the BBSS mode
and successfully changing parameters.
This parameter determines if this feature
is switched on or off, switching it on will
cause more drain on the battery. The
choices available for this parameter are:
>OFF: Sounds switched off.
>ON: Sounds switched on.
>CANCEL: Cancel editing and leave the
parameter unchanged.
TONES
THE TONES PARAMETER
This parameter sets the Geo emits a tone
each time any of the pushbuttons on the
Navigation Console are activated. As part
of the Smart menu system the TONES
parameter will only be shown in the
Hardware Menu if the SOUND parameter is
switched on. The choices available for this
parameter are:
>OFF: Tones switched off.
>ON: Tones switched on.
>CANCEL: Cancel editing and leave the
parameter unchanged.
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR GEO
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTERS
PARTS LIST
SPARES & ACCESSORIES
To Next Page
Loading...
Need help?
General
