Why my ECM Coffee Maker does not work?
If your machine isn't working, check these potential causes: If the orange control lamp is off, the water tank may be empty. If the orange control lamp is off after refilling water, switch the machine off and on again, ensuring the floater in the water tank is correctly positioned with the magnet pointing inward and upward. Also, ensure the water tank is properly fixed in place.
Why is there little or no crema on my ECM MECHANIKA VI SLIM Coffee Maker?
Lack of crema can be due to several factors: the coffee grind might not be fine enough, the coffee could be too old, there might be too much chlorine in the water, the amount of ground coffee may not be sufficient, or the shower screen could be dirty. To resolve this, try using a finer grind, tamping the coffee more firmly, using fresh coffee, using a chlorine filter, ensuring you use the right amount of coffee (check the markings inside the filter basket), or cleaning the brew group.
What to do if my ECM Coffee Maker dispenses coffee drop by drop?
If your coffee maker is dispensing coffee slowly, it could be because the grind is too fine or there is too much ground coffee. Try using a coarser grind, tamping the ground coffee only slightly, or using the correct amount of coffee, referring to the markings inside the filter basket for guidance.
Why is my ECM MECHANIKA VI SLIM producing weak coffee?
A weak coffee body can result from several issues: the grind might not be fine enough, the coffee could be old, the amount of ground coffee may be insufficient, or the shower screen might be dirty. Try using a finer grind, using fresh coffee, ensuring you use the correct amount of coffee (refer to the markings inside the filter basket), or cleaning the shower screen.
What to do if my ECM MECHANIKA VI SLIM Coffee Maker produces foam instead of crema?
If you're getting foam instead of crema, the coffee beans might be improper, or the coffee grinder setting may not be suitable for the beans you're using. Try using different coffee beans and adjusting the coffee grinder accordingly, as changing the grind can be necessary when you change coffee beans.
What to do if portafilter is dripping in ECM MECHANIKA VI SLIM?
If the portafilter or brew group is dripping, it might not be fixed properly, or the group gasket could be broken. Ensure the portafilter is securely fixed. If the issue persists, consider changing the group gasket and shower screen.
Why does the orange LED flash on my ECM MECHANIKA VI SLIM Coffee Maker and the machine stops heating?
The orange LED flashing (3 seconds on, 1 second off) indicates that ECO mode is activated. Operate the brew group lever for a short time.
Why does the coffee extraction stop and start again on my ECM MECHANIKA VI SLIM Coffee Maker?
The coffee extraction stopping and starting suggests that preinfusion mode is activated.
General| Type | Espresso Machine |
|---|---|
| Pump Type | Vibration Pump |
| Power | 1200 W |
| Manufacturer | ECM |
| Model | Mechanika VI Slim |
| Boiler Material | Stainless Steel |
| Boiler Volume | 0.75 liters |
| Pump Pressure | 15 bar |
| Material | Stainless Steel |
| Voltage | 230 V |
| Frequency | 50-60 Hz |
| Water Tank Capacity | 2.8 liters |
To Next Page
