Ecobee ecobee3 - Step 2: Wire Identification and Management; Wire Labeling and Reference; Jumper Wires and Base Removal

15
Look at the wires coming out of the wall. Take a picture for
reference.
Be careful not to let any wires fall back into the wall! Tip: Leave
the wires attached to the base until you are ready to install your
ecobee
3
.
Rc Rh G Y W C
C
R
Y
W
G
Using the old
thermostat base as
a guide, label each
wire coming out of
the wall with the
provided stickers.
Discard any jumper
wires between
Rh, Rc, or R. Your
ecobee
3
does not
need them. They
are jumpered
automatically.
When done, remove the old thermostat
base by unscrewing it from the wall.