Cool Min On Time Sets the minimum equipment run
time in cool mode.
Heat Min On Time Sets the minimum equipment run
time in heat mode.
Temperature Correction
This will allow you to program an oset between what
temperature the Thermostat is measuring versus what
is displayed. If you nd that the temperature where the
Thermostat is mounted does not represent the room
temperature, this oset allows you to compensate for
that dierence.
Installer Code
This option lets you enable or disable 3262 as the
installer code. Adding an installer code prevents
accidental modications to the installation setting. If a
user code has been programmed it will be required to
enter the installation setting.
Test Equipment
This section allows you to manually turn on and o the
various equipment connected to the Equipment Interface,
in order to test the wiring and connections.
If an optional Remote Sensor module is installed this
section will display the actual value (in ohms or volts)
being read by the module for each individual sensor.
Warning: Compressor protection and minimum run-time
features are not enforced while in this mode.
In any of the screens within this section, the equipment
will turn o when you select Done.
Sensors
This section will allow you to congure the sensor inputs
on the Equipment Interface as well as the sensors on the
optional remote sensor module (EB-RSM) Refer to page
32 for details on Automation and how to program the
sensor inputs.
View Wiring Diagram
This feature allows you to view the terminal connections of
the equipment interface as determined by the conguration
options selected during the installation process.
27 System Set-Up
Contractor Info
Enter your contact information in this area to have it
displayed in the About menu, found in the Settings
menu, when an alert is shown on the touch screen and in
the customer’s personal web portal. You can enter your:
Company name
Phone number
Email address
Website address.
This information can also be congured on the ecobee
EMS Web Portal. Once the Thermostat is connected
to the Internet this information will be automatically
loaded into the Thermostat.
Reset Installation Settings
This will restore all the installation settings back to the
factory default. Any user settings (not related to the
equipment installed) will remain unchanged.
Reset All Setting
Selecting this option will reset the entire ecobee EMS
back to the original factory default settings
Setting up Reminders and Alerts
Use the scroll bar to the right of the list to see all of the
settings. These alerts and reminders, along with the
contractor contact information (if programmed) will be
displayed on the touch screen, displayed on the EMS
Web Portal and emailed to those recipients who have
selected this option.
HVAC Maintenance
The Maintenance reminder generates an alert telling the
user that regularly scheduled maintenance is required.
Select this item to turn the reminder on or o, to show
the date of the last service and to set a reminder interval
between 1 and 12 months.
Furnace Filter
Select this item to turn the reminder on or o and set the
reminder interval in run-time hours or calendar months.
You can also check the date of the last lter change.
To set up reminder alerts:
From the Home
screen, Press More.
Press Settings and
select Reminders
and Alerts from
the menu.
System Set-Up 28
To Next Page
Loading...
