Ecobee EMS - Page 31

Low Humidity Alert
Select this item to set the humidity level at which the
EMS will generate a Low Humidity alert. The range can
be adjusted to:
O – no alert will be generated
Set humidity range of 5 – 95% R.H. in 5% increments
High Humidity Alert
Select this item to set the humidity level at which the
EMS will generate a High Humidity alert. The range can
be adjusted to:
O – no alert will be generated
Set humidity range of 5-95% R.H. in 5% increments
Auxiliary Heat Run-Time Alert (optional)
If you have a heat pump with auxiliary heat conguration,
you can program the EMS to generate an alert if the
auxiliary heat runs for more than this programmed
amount of time during a 24-hour period.
Auxiliary Outdoor Temperature Alert (optional)
If you have a heat pump with auxiliary heat conguration,
you can also program the EMS to generate an alert
if the auxiliary heat is called for when the outdoor
temperature exceeds this programmed set point. You
need an internet connection for this feature to function.
NEW Enable Alerts to be displayed on console
Select No, if you do not want any of the alerts to be display
on the touch screen interface. Alerts will continue to be
displayed on the web portal and sent via email.
NEW Enable Heating and Cooling Alerts
Select No, if you do not want the Thermostat to
generate the System Failed to Heat or Cool alerts.
If disabled, these alerts will not be shown on the
Thermostat or web portal and no emails will be sent.
Humidity Filter (Optional)
Select this item to turn the reminder on or o to choose the
reminder interval in run-time hours or calendar months.
You can also check the date of the last lter change.
Dehumidier Filter (Optional)
Select this item to turn the reminder on or o and to select
the reminder interval (in hours or calendar months). This
reminder also displays the date of the last lter change.
UV Lamp
Sets the reminder period for cleaning or replacing the
UV lamp. Select this item to turn the reminder on or o
and to set the reminder in calendar months. You can
also check the date of the last lamp change.
Ventilator Filter (Optional)
Select this item to turn the reminder on or o to choose
the reminder interval in run-time hours or calendar months.
You can also check the date of the last lter change.
Note: If a humidifier, dehumidifier or ventilator is not
configured in the accessory relays, these options will
not be displayed.
Alerts
The ecobee EMS can generate alerts when the temperature
in the building reaches a pre-programmed level. This
protects the building from damage due to freezing and/or
excessive heat.
Low Temperature Alert
Select this item to set the temperature at which the EMS
will generate a Low Temperature alert. The range can be
adjusted to:
O – no alert will be generated
Set temperature range of 35° – 68°F (1.5° – 20°C).
High Temperature Alert
Select this item to set the temperature at which the EMS
will generate a High Temperature alert. The range can be
adjusted to:
Off – no alert will be generated
Set temperature range of 60° – 104°F (15.5° – 40°C).
29 System Set-Up System Set-Up 30