Ecobee EMS - Page 35

Shut down AC The air conditioning system will
shutdown and will remain shutdown until this
input has cleared.
Adjust Temperature** When the input is activated
the heat and/or cool set points can be adjusted by
a preprogrammed amount. It will revert back to the
original set point when the input has cleared.
Activate Output Relay*** When the input is
activated, a User dened relay will be activated.
Send Alert Choosing Yes enables the system to send
an alert when the input has been activated.
Send Update Log Choosing Yes, enables the
system to log when this input has been activated.
Activation Delay Allows you to program a time
delay from when the input detects the active state
to when the action programmed in the Type section
is performed by the system. For example, if you
connect a door sensor to the input and program a
ve-minute activation delay, the door will need to
open and remain open for ve-minutes before the
Thermostat takes action.
Deactivation Delay Allows you to program a time
delay from when the input detects the inactive
state to when the system reverts back to its normal
operating conditions. For example, if you connect a
door sensor to the input and program a ve-minute
deactivation delay, the door will remain closed for
ve-minutes before the Thermostat will revert back
to the normal operating condition.
Min Action Duration Allows you to program the
minimum amount of time the system will perform
this action. This timer will run its course regardless
of whether the input has reverted back to its normal
state and the deactivation timer has expired. This
option is useful for applications where you want to
run a device (i.e., fan or compressor) for a minimum
amount of time after the input has been activated
rather then using the deactivation delay. This
ensures the fan or motor does not short cycle.
33 Automation
** If Adjust Temperature is chosen as the Type, you will
also be presented with the following options:
Decrease Heat Temp Allows you to program the
number of degrees that the heat set temperature
will be adjusted by once an input has been
activated. On the scroll wheel of the Thermostat, a
positive number increases the heat set point and a
negative number decreases the heat set point.
Increase Cool Temp Allows you to program the
number of degrees that the cool set temperature
will be adjusted by once an input has been
activated. On the scroll wheel of the Thermostat, a
positive number increases the cool set point and a
negative number decreases the cool set point.
In both cases this oset will apply to the set point
temperature at the time of the activation of the
input. As the system switches between program
periods (i.e., occupied, unoccupied, etc) this
oset will be maintained. Once the input has
been switched back to the inactive state the set
temperature will revert back to the normal limits.
*** If the Activate Relay Output option is chosen
as the Type you will also be presented with the
following options:
Set Relay Allows you to determine if the User dened
relay should open or close when the input is activated.
Use Relay Allows you to select which of the accessory
relays, congured as ser Dened, should be engaged
when the input is activated. You must have congured
at least one accessory relay as User dened prior to
completing this section.
It is possible to have more than one type of action per
input or to use the same input and program one action
for when it’s opened and another for when it is closed.
To program this, simply repeat the steps above until
each input is programmed as desired.
Automation 34