Step 3: Pedal mounting
1) The pedals on the axle are marked with the letter "R" or "L".
2) Tighten the pedal by the letter "R" clockwise in the clockwise direction. Then
tighten it with key # 15 with a force of 34 Nm.
3) Tighten the pedal by the letter "L" on the left counterclockwise. Then tighten
it with key No. 15 with a force of 34 Nm.
Step 4: Adjust the brakes
The brakes should be set up already at the factory, but the cables tend to
deregulate, so they need to be checked after the first test drive. Adjustments
should also be made during use of the bicycle in case of necessity. If you need
additional consultation, please contact a professional cycling center.
Step 5: Install the front wheel
The front wheel is disassembled, so after opening the carton, remove the
protective foil and fit on the front fork.
To Next Page
Loading...
