2. Installation
1. Turn off the power
To prevent electrical shock and/or equipment damage, disconnect electrical power at the main fuse or circuit
breaker before installation and maintenance. Be aware that even if the circuit breaker is off, some voltage may
remain in the wires — before proceeding with the installation, be sure no voltage is present in the wiring. Take
extra precautions to avoid accidentally turning the device on during installation.
2. Connect the device exactly according to the diagrams shown below
The dimmer is available for 2 and 3 wired connection. Please note in case of a 2 wired connection port 3 and
Load must be connected to make stable dimming possible.
3. Turn the power back
3. Min./Max./Dimming Speed adjustment
To Next Page
Loading...