pag.13
LB 448 Blu 500 ÷ 1400 P AB B
POSITION OF ELECTRODES
SHIFTING FROM NAT. GAS TO L.P.G.: Remove the front disk from the firing head and fit the rear disk.
SHIFTING FROM L.P.G. TO NAT. GAS: Remove the rear disk from the firing head and fit the front disk.
POSITIONING THE DISK FOR NATURAL GAS AND L.P.G.
2Ö3mm
2Ö3mm
BLU 500-700-1000 PAB
BLU 1200-1400 PAB
Ignition electrode
Ionization probe
Ignition electrode
Ionization probe
REMOVING THE NOSEPIECE
In order to change the burner operation from natural gas to LPG you have to
follow these instructions (as shown in figure).
- remove the disc from combustion head. - carry out the thread M6 on the 3
holes Ø 5. - put on each threaded hole a screws M6.
- replace the disc on the combustion head.
M6
HOW TO CHANGE BURNER OPERATION FROM
NATURAL GAS TO LPG - BLU 500
ONLY BLU 700-1000 PAB
SHIFTING FROM NAT. GAS TO L.P.G.: Remove the front disk from the firing head
SHIFTING FROM L.P.G. TO NAT. GAS: Fit the front disk to the firing head
Open
Closed
NATURAL GAS
L.P.G.
Blu 1200
Blu 1400
To Next Page