Ecoflam MAX 20 User Manual (English)

Other manuals for Ecoflam MAX 20

Manual40 pages

Technical Data, Operating Instructions, Electric Diagrams, Spare Parts List80 pages

Questions and Answers:

R
Ronald MarshAug 8, 2025
What to do if Ecoflam Burner starts and then shuts down after solenoid valves open?
- J
  jennifer12Aug 9, 2025
  If your Ecoflam Burner starts but shuts down after the solenoid valves open, it indicates no flame signal at the end of the safety time. First, ensure the oil level in the tank is adequate and the valves are open. Then, examine the oil pressure, pump operation, coupling, filter, and solenoid valve. Next, check the ignition circuit and electrode adjustment, cleaning or replacing electrodes as necessary. Finally, clean or replace the flame monitor. If problems persist, consider replacing ignition electrodes, ignition cables, the ignition transformer, nozzle, pump, solenoid valve, or the automatic combustion control unit as needed.
S
Suzanne CameronAug 15, 2025
Why Ecoflam MAX 20 does not start after thermostat shutdown?
- B
  Bryan JohnsAug 15, 2025
  If your Ecoflam Burner doesn't start after the thermostat shuts down and there's no malfunction indicated on the automatic combustion control unit, it could be due to a drop in supply voltage, a power failure, or a control unit malfunction. You should check for the cause of the voltage drop or power failure. If those aren't the issue, replace the control unit.
J
Jon WadeAug 20, 2025
What to do if Ecoflam Burner starts and shuts down after preventilation?
- C
  Cathy MackAug 21, 2025
  If your Ecoflam Burner starts and then shuts down after pre-ventilation, it may be due to flaring during pre-ventilation or pre-ignition. Check the ignition sparks and adjust or replace the electrode. Also, inspect and consider replacing the fuel-oil solenoid valve.
M
Ms. Samantha JimenezAug 27, 2025
How to fix no heat request in Ecoflam MAX 20 Burner?
- R
  Ronald SmithAug 27, 2025
  If there is no heat request in your Ecoflam Burner, it means the thermostats are either defective or incorrectly adjusted. To resolve this, adjust the thermostats or replace them if necessary.
G
Gerald Stewart MDSep 1, 2025
What to do if Ecoflam MAX 20 Burner starts briefly and shuts down with red LED on?
- W
  William HunterSep 1, 2025
  If your Ecoflam Burner starts briefly when switched on, then shuts down and the red LED lights up, it indicates that the control unit has been intentionally locked. To resolve this, reset the control unit.