45
22. Ho
w to check the serial number of the product?
There are 3 ways to check the serial number (SN):
①
Check the packing box. An SN label is attached on the side of the packing box.
②
After removing the battery compartment cover, scan the QR code shown in the gure to
check the SN.
③
Open the app and go to Settings to check it.
23. Are physical cables required in the mowing zone of the robotic lawn mower?
It is not necessary to bury any cables. A virtual boundary will be generated after a map is
created through remote control of the robotic lawn mower. The robotic lawn mower will
automatically plan the routes within the boundary for mowing.
24. What should I do if the charging pads of the charging station are blackened?
Charging may fail if the charging pads are blackened. Please polish the blackened area with
dry sand paper. Also check whether the charging pads of the mower are blackened, and
polish them if so.
25. How is the cutting height dened?
The cutting height refers to the height from the blade disc to the tire. The actual height of
cut grass will be larger than the set value as the grass is soft.
26. How to distinguish the front and rear of a robotic lawn mower?
The side in contact with the charging pads of the charging station is the front, and the side
with the rear wheel handle is the rear.
27. What does the work time delay mean? What's its role?
The rain-caused work delay refers to the function where the robotic lawn mower
automatically returns to the charging station due to the rain. When it is detected that the
rain has stopped, the mower will not resume the mowing task immediately, but begin the
countdown as per the delay time set in advance, and start mowing after the countdown is
over. This can protect the lawn by avoiding the mowing operation of robotic lawn mower
when the lawn is damp.
28. How is the operating route of the robotic lawn mower planned?
When robotic lawn mower is used for the rst time, remotely control it to set the virtual map
boundary. After the map is created, the robot will perform mowing along the route planned
by the algorithm, but not move randomly.
29. What should I do when the container is full?
When the container is full, the app will prompt that "Fallen leaves container is full. Please
clean it soon". Please manually empty the leaves from the container, so that the mower can
continue the cleaning task.
30. How many leaves can be collected in the container?
The maximum dimensions of the container are 404 × 390 × 265 mm (16 × 15.4 × 10.5 in.),
and the volume is approximately 0.03 m³ (1.06 ft³). It can collect dry fallen leaves weighing
approximately 1 kg (2.2 lbs). The specic collecting capacity depends on the species of
fallen leaves and the collection environment.
To Next Page
Loading...
