Ecolab Apex2 User Manual

Set length of detergent dispense:
Range: 1-30 seconds, interval of 0.1 seconds
Default: 2.5 seconds
Set frequency of detergent dosing:
Range: 1-10 racks, interval of 1 rack
Default: 1 rack
Set the initial detergent charge after machine fill Range.
1-999 seconds. Interval 37 sec.
Set rinse pump speed:
Range: 8-30RPM, increments of 0.5RPM
Default: 15RPM
Set third product rinse speed:
Range: 8-30RPM, increments of 0.5RPM
Default: 15RPM
Adjust Dispensing: Flight Probe
Adjust Detergent
Adjust Rinse Aid
Adjust Third Product
Set detergent concentration:
Range: 1-100, increments of 1
Default: 50
Titrate machine sump to determine concentration.
Use Probe Diagnostics to determine when machine is at set point.
Machine is at set point when Temperature Compensated Value
equals Detergent Set Point.
See “Diagnostics & Troubleshooting --> Probe Diagnostics”
Adjust Detergent Setpoint
1
Adjust Detergent
Adjust Rinse Aid
Adjust Third Product
Back
Set rinse pump speed:
Range: 8-30RPM, increments of 0.5RPM
Default: 15RPM
Prime the rinse line for 30 seconds at the programmed Rinse
Pump Speed.
Adjust Rinse Pump Speed
Rinse Pump Prime
Adjust Rinse Pump Speed
Rinse Pump Prime
01
Adjust Detergent
Adjust Rinse Aid
Adjust Third Product
Back
Set third product pump speed:
Range: 8-30RPM, increments of 0.5RPM
Default: 15RPM
1
Adjust Detergent
Adjust Rinse Aid
Adjust Third Product
Back
Adjust Third Product Pump Speed
Logout
View Information
Adjust Dispensing
Diagnostics & Troubleshooting
Setup System
50
15.0 RPM
15.0 RPM
Press start to begin priming
32

Ecolab Apex2 Specifications

General

Brand	Ecolab
Model	Apex2
Category	Control Systems
Language	English