Mounting note for clamp exchange
Connexx Basic 182603 Connexx Switch 182604
When connexx system is installed and running with product you have to wear
appropriate protective garments and protective goggles and should proceed
as follows:
1. Loosen screws of the lower tube clip and slide it upwards
2. Fasten one holding angle with the delivered fasteners on the mounting plate align to
the bottom
3. Loosen screws of the upper tube clip
4. To open the clamps of the tube clips easily lift off both clips over the tube
5. Fasten second holding angle with the delivered fasteners on the mounting plate align to
the top
6. Put the two threaded bolts through the holes as shown in the picture and fix it with the
locknuts (do not tighten - just aligned)
Montagehinweis_Connexx 06/2004
To Previous Page
Loading...
