Ecolab Elados EMP III-E00 - Deviant Datas - Pumps in the Higher Pressures (HP) Versions; General Data - Standard Pumps; Materials

417102233 Betriebsanleitung EMP III E00, E10
- 50 -
Rev. 02-11.13
11.3.2 General data – Standard pumps
Description
Pump type
00160
00250
00540
00800
01200
Pump output [l/h]*/**
16
25
54
80
120
Max. metering backpressure [MPa (bar)]**
1 (10)
0,4 (4)
0,3 (3)
Max. permissible pre-pressure [bar]
0,8
0,6
Number of strokes [1/min] at 50 Hz
122
Metering quantity/stroke [cm³]
2,1
3,4
7,3
10,8
16,1
Metering accuracy [see chapter 11.6]
< ± 3%
Max. conveyable viscosity [mPas]
200
Permitted ambient temperature
5-40°C
Suction height [mWs] at 100 % stroke***
0,05 (0,5)
Noise level (DBA) in 1 m distance
(according to DIN EN 12639/ EN ISO 9614-2)
48,0
Max. pre-pressure (suction side) [MPa (bar)]
0,5
Recommended minimum diameter of suction/pressure
connector [ID mm]
6 mm
PVC tube 6/12, 10/16
12 mm
PVC tube 12/21
Weight [kg]
7,4
8,6
* all data relate to water at 20 °C
** At mains power frequency 60 Hz, the delivery capacity increases by 20 %, while metering backpressure decreases 20 %.
*** Suction heights with clean, moistened valves at 100 % metering stroke and max. stroke frequency.
CAUTION
With reference to DIN EN 809 5.2.3, please be advised that the surface temperature of the
motor may exceed 80°C under certain circumstances. Therefore, ensure that this area
cannot be touched during operation!
11.3.3 Deviant datas – Pumps in the “Higher Pressures (HP)” versions
Description
Pump type
00160
00250
Pump output [l/h]*
14,7
23,5
Max. metering backpressure [[MPa (bar)]
1,6 (16)
1,2 (12)
Metering quantity/stroke [cm³]
1,98
3,15
* all data relate to water at 20 °C
11.4 Materials
Pump-head: PP, optionally PVDF, stainless steel 1.4571
Diaphragm: PTFE-EPDM composite
Seals: FPM (Viton B), optionally EPDM, Kalrez
Valve-balls: Ceramics, optionally stainless steel 1.4401, PTFE
Valve-springs: Hastelloy C4
Housing: Thermoplastic polyester
Colour: Blue, RAL 5007
Special versions available on request.